Home › Forums › TWAIN Classic › Scanning positive films using a TMA
- This topic has 2 replies, 2 voices, and was last updated 15 years, 5 months ago by leonardo-ferreira.
- AuthorPosts
Hello,
I’m new to Twain and I am developping an interface to scan x-Ray films using a Twain compatible scanner equipped with a TMA (it’s a Microtek ScanMaker i800).
I need to setup my application to activate the TMA. I know this can be achieved using the software provided by Microtek, the ScanWizard Pro, but I need my application to set this up without using any other interface. Which Twain capability must I set to activate the TMA or which capabilities shoud be dealt with to scan positive (x-ray) films ?
Thank you in advance for any help.
Regards,
Leonardo@leonardo-ferreira wrote:
…I am developping an interface to scan x-Ray films using…a Microtek ScanMaker i800…
Take a look at ICAP_LIGHTPATH in the specification. I don’t know if Microtek’s data source for the ScanMaker i800 supports this.
–
@dpenney wrote:
@leonardo-ferreira wrote:
…I am developping an interface to scan x-Ray films using…a Microtek ScanMaker i800…
Take a look at ICAP_LIGHTPATH in the specification. I don’t know if Microtek’s data source for the ScanMaker i800 supports this.
–
Thank you very much for your help. Microtek source actually supports and after setting the ICAP_LIGHTPATH correctely the TMA was activated.
Regards,
Leonardo.
- AuthorPosts